Compex LinkPort ENET-C Guide d'installation télécharger pdf (Page 44)

Installation 44

switchport

switchport trunk encapsulation dot1q

switchport trunk allowed vlan 10,20,30,40

switchport mode trunk

no ip address

speed 1000

channel-protocol lacp

channel-group 10 mode active

Failover and check-pointing

VCM runs as a high-availability pair when VC-Enet modules are installed in horizontally adjacent

interconnect bays. The active VCM is usually on the lowest odd numbered bay when the enclosure is

powered up.

Each time a configuration is changed, it is written to local flash memory and then check-pointed to the

standby module. Configurations can also be backed up to a workstation using the GUI or Virtual Connect

Support Utility.

NOTE: HP recommends saving a configuration after each session and before updating

firmware.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 139 140

Pas de commentaire

Compex LinkPort ENET-C Guide d'installation Page 44