Compex LinkPort ENET-C Guide d'installation Page 43

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 140
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 42
Installation 43
On switches running CatOS, you can only change channel mode per module. In the following example,
change the channel mode for slots 1 and 2 by using the following command:
set channelprotocol lacp module_number
Verify the changes by using the following command:
show channelprotocol.
CatOSSwitch (enable) set channelprotocol lacp 1
Mod 1 is set to LACP protocol.
CatOSSwitch (enable) set channelprotocol lacp 2
Mod 2 is set to LACP protocol.
CatOSSwitch (enable) show channelprotocol
Channel
Module Protocol
------- --------
1 LACP
2 LACP
3 PAGP
5 PAGP
On switches running Cisco IOS Software, specify which interfaces should be using LACP by entering the
following interface configuration command:
channel-protocol lacp:
CiscoIOSSwitch(config-if)#channel-protocol lacp
Example switch configuration of a Cat 6500 switch using IOS. Ports 7/46, 7/47, and 7/48 on the Cat
6500 switch are used to uplink to the Virtual Connect module:
interface Port-channel10
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 10,20,30,40
switchport mode trunk
no ip address
interface GigabitEthernet7/46
description test-VC
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 10,20,30,40
switchport mode trunk
no ip address
speed 1000
channel-protocol lacp
channel-group 10 mode active
!
interface GigabitEthernet7/47
description test-VC
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 10,20,30,40
switchport mode trunk
no ip address
speed 1000
channel-protocol lacp
channel-group 10 mode active
!
interface GigabitEthernet7/48
description test-VC
Vue de la page 42
1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 139 140

Commentaires sur ces manuels

Pas de commentaire