Compex SGX3226 Spécifications télécharger pdf (Page 60)

Chapter 7 Advanced Configuration for Compex SGX3226

may name your switch for identification. Refer to Section 8.3 “System

Configuration” for details.

2. Next, disconnect one end of the Ethernet cable from SGX3226 Unit #1

and establish a link to Unit #2. Please refer to Figure 7.2.

3. Go the MS DOS Prompt and enter this command:

arp –d 192.168.100.128.

This will delete the ARP cache so that you can access to Compex

SGX3226 successfully. Please note that adding the IP address in the

ARP command allows system to delete the ARP cache which is

belonged to that particular device.

4. Enter http://192.168.100.128 in the internet browser to select Slave

option in the field provided. Give a name to your switch.

NOTE

You may also use the console port to activate the stacking function of all

switches. We are using 3 switches in this example, therefore, please repeat the

procedures of Steps 1 and 2 for SGX3226 Unit #3. Select Slave option in the

Stacking State field.

Figure 7.2 Establish a connection to SGX3226 Unit #2

5. After selecting the options for individual switches, use RJ45 Ethernet

MDI straight cables to connect all three switches as shown in Figure

7.1 and power up all switches.

SGX3226 Unit #2 (Slave)

192.168.100.128

SGX3226 Unit #1(Master)

192.168.100.128

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 89 90

Pas de commentaire

Compex SGX3226 Spécifications Page 60