Compex WP54G 1a Guide d'installation télécharger pdf (Page 7)

Chapter 2 Let’s Get Going - Hardware Setup

Method Two: Using Compex PoE to supply power to the unit

Compex Power-Over-Ethernet (PoE) is fully compatible with our Compex

WP54G. This accessory supplies operational power to the wireless AP via the

Ethernet cable connection.

Users who have already purchased the Compex PoE and who wish to use it to

supply power to the Compex WP54G may follow the installation procedures as

shown below:

Connect the external antenna to the SMA

connector of Compex WP54G.

Use an RJ45 Ethernet cable to connect one end of the cable to the Ethernet

socket of the Injector and the other end to one of the LAN ports of Compex

WP54G.

Warning:

When one port is used for PoE, the other port cannot connect to any other

network device.

Maximum length of the RJ45 Category 5 cable is 100 metres.

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Pas de commentaire

Compex WP54G 1a Guide d'installation Page 7