Compex LinkPort ENET-C Manuel d'utilisateur télécharger pdf (Page 16)

Compex LinkPort PCMCIA Ethernet Card

Chapter 3

Software Installation

Introduction:

Enabler program: Lanenb.EXE

↵LANENB enabler is provided to configure Compex

LinkPort ENET-B in DOS environment.

↵Before any driver (either loaded from Config.sys or

Autoexec.bat or any batch file) can initialize the adapter,

LANENB must be run first to configure it.

↵If PCMCIA Card and Socket Services software is run in

the machine, LANENB.EXE must run immediately after

this (Card and Socket Services) software is loaded, but

before loading the network driver.

↵LANENB.EXE cannot be unloaded. The machine must

reboot and LANENB.EXE re-run to change to a new I/O

Address and Interrupt Number.

To run LANENB.EXE, insert the driver diskette in drive

A:\ and type the following:

A:LANENB [/IRQ=dd] [/IOP=XXX]

A:LANENB [/HLP] or [/?]

A:LANENB [/CHK]

where:

[/IRQ]

Interrupt line keyword of the adapter.

[/IOP]

I/O Base Address keyword of the adapter.

is a one/two digit number representing the

interrupt line (Valid value: 3, 4, 5, 7, 9,

10, 11*, 12, 15). [*Default IRQ]

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Pas de commentaire

Compex LinkPort ENET-C Manuel d'utilisateur Page 16